Can you put deck tile over grass?
You will be pleased to learn that, YES, outdoor deck and patio tiles can be easily installed on uneven ground, grass and dirt. They can be used as a permanent, temporary or even portable outdoor floor. Many companies only sell interlocking patio tiles that work when installed over even, flat and hard ground.
Can you put composite decking tiles on grass?
Just as it is with deck tiles, you cannot lay composite decking directly on grass. You will face the same issues, including potential for mold growth and ground movement. Instead, place your NewTechWood UltraShield® Naturale™ on solid surfaces, such as: Concrete sidewalks or other paved areas.
How do you lay deck tile on the ground?
Installation Over An Uneven Surface
- Start by removing any grass and plants that are the area.
- Then depending on how high you want the tiles to be, you may need to dig out a couple of inches of soil.
- Install edging around the perimeter.
- Lay down landscape fabric.
- Fill the area with at least 2” of pea gravel.
Do I need to remove grass before decking?
If your decking hasn’t been laid yet, remove or kill the grass in the area that it will go on. By doing so, weeds are less likely to become established and spread. Also, you’re less likely to have grass growing through your decking.
How do you install decking over grass?
If you’re laying your deck straight onto the ground, cover the area with a layer of weed control fabric. Then add 40 mm to 50 mm of gravel on top. The other method is to create concrete pads for the deck to sit on top of. This will reduce the likelihood of moisture seeping into the frame and causing damage.
Can you put composite decking directly on the ground?
Decking boards must NEVER be laid directly on the ground but instead should be fixed to joists of a suitable sub-frame. In most cases we recommend installing your Alpha Composite Decking on a solid concrete base using plastic composite joists.
How do you lay decking on uneven grass?
To build a decking base on sloped uneven ground:
- Clear the area of all grass, weeds and debris using a good quality spade.
- Dig 1ft deep post holes.
- Set the posts using post mix so that the top is at or slightly above the desired height.