How are pipe thread sizes measured?
When measuring a female pipe thread (FPT), measure the OD of the pipe itself and subtract ¼ inch to find the correct pipe thread size. Perhaps even easier than this is to purchase a measuring tool called a caliper that will measure OD and inside diameter (ID).
What is NPT gauge?
NPT thread gauges, the full name is National Pipe Taper thread gauges(full name:American National Standard Taper Pipe Thread gages) NPT threads used on threaded pipes and pipe fittings, they are tapered for sealing, no need any thread sealant.
How do I check my NPT thread gauge?
To gage Internal N.P.T. taper pipe threads, screw the N.P.T. thread plug firmly into the product – do not force. The thread is within the permissible tolerance when the gaging notch of the plug is not more than one turn plus or minus from being flush with the end of the product.
What are the different pipe threads?
Sizes
| NPT | American Standard Pipe Taper Thread |
|---|---|
| NPSL | American Standard Straight Locknut Pipe Thread |
| NPTF | American Standard Pipe Thread Tapered (Dryseal) |
| BSPP | British Standard Pipe Thread Parallel |
| BSPT | British Standard Pipe Thread Tapered |
How do you use a NPT L1 gauge?
Calibration Procedure: Lubricate the gages with light oil. Assemble the NPT-L1 Work Plug Gage into the NPT Master Ring Gauge with hand tight pressure. Take a measurement from the NPT Master Ring Gage Large End Face to the NPT-L1 Work Plug Gauge Basic Notch. Record this measurement in your calibration record.
How do you use L1 thread gauges?
The L1 gage is used as a guide to determine the gaging position. If the basic gage notch is flush with end of the product, the threads are considered to be basic. The plain plug gage used on the same fitting should show the end of the product at or between the basic maximum and minimum notches.
What size thread is 1/2 pipe?
Basic Dimensions, American National Standard Taper Pipe Threads, NPT, (ANSI B2. 1-1968)
| Nominal Pipe Size | Outside Diameter of Pipe | Height of Thread |
|---|---|---|
| 1/4 | 0.540 | 0.04444 |
| 3/8 | 0.675 | 0.04444 |
| 1/2 | 0.840 | 0.05714 |
| 3/4 | 1.050 | 0.05714 |
How do you use NPT gauges?
For NPT threads there is only one test required. Thread the L-1 gage onto or into the tapered thread until the fit is hand tight. When the gage stops, the notch on the plug gage or the flat of the ring gage, should be within plus or minus one turn from the entry face of the thread.
What size is 1/16 pipe thread?
Basic Dimensions, American National Standard Taper Pipe Threads, NPT, (ANSI B2. 1-1968)
| Nominal Pipe Size | Outside Diameter of Pipe | Wrench Makeup Length for Internal Thread |
|---|---|---|
| 1/16 | 0.313 | 0.1111 |
| 1/8 | 0.405 | 0.1111 |
| 1/4 | 0.540 | 0.1667 |
| 3/8 | 0.675 | 0.1667 |