How much oil does a 4.0 Tacoma take?

Table of Contents

Capacity: 4WD, With filter 5.5 quartsAfter refill check oil level.

What kind of oil does my 2006 Toyota Tacoma take?

According to the owner’s manual, the 2006 Toyota Tacoma uses 5W-30 weight oil. There is no stated preference for conventional or synthetic. The 2.7L (164 ci) 4-cylinder engine uses approximately 6 quarts for an oil and filter change. The 4.0L (241.41 ci) V6 will use between 4.5 and 5 quarts of oil.

What kind of oil does a Tacoma 4.0 take?

5W-30
5W-30 is the best choice for good fuel economy and starting in cold weather. If 5W-30 is not available 10W-30 may be used. However, it must be replaced with 5W-30 at the next oil change.

How many quarts of oil does a Tacoma V6 take?

The Tacoma takes SAE 0w-20 synthetic oil. The 2.7L (164 ci) 4 -cylinder engine holds 6.2 quarts, the 3.5L (211 ci) V6 engine holds 6.1 quarts (6.2 with a tow package).

Can I use synthetic oil in my Toyota Tacoma?

Toyota Tacoma uses oil viscosities 0W-20 and 5W-20. Fully synthetic solutions are best and keep your engine running smoothly for longer and prevent sludge buildup.

What kind of oil does a 2007 Toyota Tacoma 4.0 take?

The 2007 Tacoma’s 4.0L V6 engine option uses 5W30 synthetic oil. The specific weights vary based on trim and drive package: the RWD PRE (5.5 quarts), the RWD base (4.8 quarts), the RWD XRUN (4.8 quarts), and the 4WD (5.5 quarts).

How much oil does a 2005 Tacoma V6 take?

5.5 quartsAfter
4WD, With filter 5.5 quartsAfter refill check oil level. Top off to proper level as needed.

How much oil does a 2005 Toyota Tacoma take?

Capacity: RWD Base, With filter 4.8 quartsAfter refill check oil level. Top off to proper level as needed.

Where is the oil drain plug on a 2006 Toyota Tacoma?

Locate the oil drain plug. The plug is located underneath the front of the truck on the bottom of the engine crank case. Warm up the engine by letting it run or driving it for 10-20 minutes to ensure the oil will flow easily.