What does the trace response h mean?

H. This error however indicates that IP network is available but the individual host 10.11. 2.4 can’t be reached. It isn’t available.

What do traceroute results mean?

A traceroute displays the path that the signal took as it traveled around the Internet to the website. It also displays times which are the response times that occurred at each stop along the route. If there is a connection problem or latency connecting to a site, it will show up in these times.

How do you read MTR results?

Sample MTR Results and How To Read Them. First of all, you need to let the MTR trace run for 10-15 minutes for best results. The most common results you need to look at are the Loss% and Last. If you are seeing 0.0% Loss% and Last is below 100 then your connection to the server is okay.

What are the 3 numbers in traceroute?

The first column is the number of hops to the destination (maximum of 30). The next three columns are the amounts of time to receive the responses. The right-most column shows the router information along the path.

What does MS mean in traceroute?

milliseconds
Hop number: The specific hop number in the path from the sender to the destination. Round Trip Time (RTT): The time it takes for a packet to get to a hop and back, displayed in milliseconds (ms). By default, tracert sends three packets to each hop, so the output lists three roundtrip times per hop.

Where is traceroute used?

Traceroute is a network diagnostic tool used to track in real-time the pathway taken by a packet on an IP network from source to destination, reporting the IP addresses of all the routers it pinged in between.

How do you know if a traceroute fails?

Do a traceroute from this router to your target server.

1. If the trace completes – The routing to the target server is working fine.
2. If the trace fails – Test the routing table and check the other status of all the hops between this router and your target destination.

How do I trace a network path?

Follow these steps to run a network path trace:

1. Open the Start menu and select Run.
2. Type cmd and select OK.
3. This will open the command prompt.
4. You should see the traffic path taken to your site.
5. Don’t worry about understanding the output.
6. Paste the output to an email and send it to the appropriate support personnel.